waterjet high pressure pump (55,000 psi )

Instruction

The choice of waterjet pump mainly depends on the sort and thickness of cutting material , quality of cutting surface and cutting speed. The 380Mpa intensifier system ,with high pressure, strong cutting ability, good cutting surface and rapid cutting speed, is especially proper to the cutting of hard material whose thickness is up to 30mm such as steel, alumimum, coppor and stone.

Technical data

1.Type of pressurization is hydraulic. (The water is pressurized by using the fluid pressure intensification principle) 

2.Max. oil discharge is 90 L/min 

3.Max. water discharge is 3.7L/min

4.Max. diameter of orifice is 0.3mm

5.Max. operating pressure is 380MPa

6.Continuous operating pressure is 330MPa        

7.Power requirement : 37KW,380V/50HZ

8.Type of shift is electronic

9.low pressure water pump fully imported from America

10.maintenance free accumulator whose capability is 1.3L using American technology

11.Intensifier is from America